A guide on using FlashWizard Pro to flash, install, repair, modify the firmware on a Dreambox receiver, also works on other Enigma 1/2 based receivers. I have run a LAN cable from my 7020 to my router, the light on the router indicates a good connection, no light on the 7020 end:mad: I have set up the address on the 7020, 192.168.1.22, (the router is 192.168.1.254) but the router does not report seeing the 7020. As an alternative I have tried DHCP but no luck there either. What have I done wrong? Yes, I have read the Idiots Guide PS I did have this working some months ago, because I installed Flash Pro and the PLi image. I do not remember any special problems at that time. I have run a LAN cable from my 7020 to my router, the light on the router indicates a good connection, no light on the 7020 end:mad: I have set up the address on the 7020, 192.168.1.22, (the router is 192.168.1.254) but the router does not report seeing the 7020. As an alternative I have tried DHCP but no luck there either. What have I done wrong? Yes, I have read the Idiots Guide PS I did have this working some months ago, because I installed Flash Pro and the PLi image. I do not remember any special problems at that time. I have tried different IP addresses, both static and DHCP on the 7020. There are both static and dynamic address ranges on the router config. I did put in the gateway address and made sure the Network box is checked. (Pli Image) I am wary of changing the router address. On the 7020 no antivirus installed or security. I just took my notebook to the other room to check the cable. The router immediately recognised the laptop on the different port. Could it be that I have a duff LAN port on the 7020? How can I test that? Flashing a new firmware by Browser What you need to flash You need the image file you want to flash. Image files have the extension *.nfi. You can't flash other images like *.img files. Don't try it - it won't work. You need either a DHCP server and a configured bootloader You need a browser and a network cable. Connect your Dreambox to a switch/hub/router in your lokal LAN. To flash a new image, you can use the second stage loader. It must be present and not broken. The following steps assume you have a DHCP server. If you don't have one, you have to (klick) in the bootloader's serial setup. - Power down the Dreambox, either using 'shutdown' and by switching off by the power switch. Standby is not enough! ![]() - (1.) Press and hold the power button. - (2.) Switch on your Dreambox. - (3.) Your Dreambox will get the next free DHCP IP address from your router. - Now, open a browser on your PC. (1.) enter in the address line '. - (2.) on the bottom of the page, there's a link called 'firmware upgrade'. - On the next page, you can select the flash image you want to flash.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
March 2019
Categories |